Soho RAID SR2000 Manuel d'utilisateur

SOHO RAID SR2000 User’s Manual P/N: P99649 Version: 2.0

2-3 How to open/close the front panel  Opening the front panel 1. Touch the right side center of the front panel with your finger as indicated by th

2-4 How to remove/insert the Removable Carrier  Removing the Removable Carrier 1. Following the indicated direction, press down and hold the Removabl

 To insert the Removable Carrier 1. Following the direction indicated by the arrow, slide the Removable Carrier along the rail into the slot end of

2-5 Installing HDD in the Removable Carrier  Set Master/Slave jumpers to MASTER (factory default).  Connect the power cord and the Removable Carrier

2-6 Installing the SR2000 in your Computer  Turn the power off.  Make sure there are two 5-1/4" Expansion bays available for the SR2000.  Set

Chapter 3 RAID Use  After proper installation, the SR2000 can be considered as one HDD.  Both FDISK and FORMAT commands have the same function on th

automatically format HDD synchronously. In addition, it will install the OS and other required software. (Refer to OS Installation Guide) 6. When the

3. First follow the reverse order of the steps described in Section 2-5 Installing HDD in Removable Carrier to remove the damaged HDD, and then repla

Chapter 4 Automatic Rebuild Function (A.R.F.)  A.R.F. supports Windows NT4.0 Server & Workstation, Windows 98*/95*/3.1X, Dos 6.22, SCO UNIX Syste

4-1 Installing an extra HDD for rebuilding  While the HDD with data is on the upper deck of the SR2000, start the computer. The computer will automat

Chapter 1 Introduction... 2 1-1 Functions and Features ...

 While data is in the HDD on the upper deck of the SR2000, start up the computer. The computer system will automatically check the status of the HDD

4-2 LCD display showing HDD status  Disk on the upper deck (Primary Disk): Fail Disk on the lower deck (Secondary Disk): OK Pri HDD：Fail Sec HDD：OK

Chapter 5 Manual Back Up  Manual back up shall be performed from the upper deck (SOURCE) to the lower deck (TARGET). Do not invert the sequence.  Ta

Turn off power 3. After confirmation, the LCD will display options for BACK UP Mode and the cursor will blink and display “F.” Use key selector to ch

7. If " Continue" is selected, it will go back to the screen indicated by step 4 as follows. Copy Mode? File Sector Auto 8. If "Quit

 File Copy Procedure 1. After entering File mode and starting operations, the LCD will show the following: 2. A few seconds later, the LCD will sho

track-by-track and sector-by-sector.  Average copy speed is 4~10 min/GB (or 6~15GB/hour, according to HDD efficiency).  Sector Copy is faster than t

5-4 Note  After completing the copy mode above, it is necessary to turn the power off and set Operation Mode Switch to NORMAL position on the control

Chapter 6 Certified HDD for SR2000 Brand Name Type Model No. Capacity (GB) Note SE 2100AT 2.1 ST 3240AT 3.2 5100 5.1 6400 6.4 10200 10.2 EX 12700A 12.

Chapter 7 Questions & Answers Q1: Why is the computer system unable to reboot or re-configure after SR2000 is installed? A:1. SR2000 supports IDE

Chapter 1 Introduction SR2000 SOHO RAID (Redundant of Array Independent Drives) provides disk mirror function for the internal RAID Level 1 for small

Q5: The buzzer alarm keeps sounding during SR2000 operation. A: Check if both Removable Carriers (hard disks installed) on the upper and lower deck

Q9: How is the HDD capacity configured when replacing with a new disk? A: 1. SR2000 is configured to the least capacity detected when SR2000 is instal

APPENDIX 1. Although the SR2000 is structured to be compatible with other HDD main brands, we will not be responsible for any data loss resulting in

1-2 Product Specifications  System Specifications Host Interface Ultra ATA RAID level 1 Installation Space 2 x 5-1/4” Expansion Bay HDD Interface

 Supports the Following OS (no drivers required) DOS, Windows NT Server, Workstation, Windows 98/95/3.1x, NetWare**3.12/4.1x/5.x, SCO UNIX, LINUX (Re

8. Normal HDD mode for SR2000 is Ultra DMA. In the event of failure to work with EIDE connector, HDD will automatically configure itself in PIO mode 4

Chapter 2 Installation 2-1 Package Contents Your SR2000 SOHO RAID package includes the following: please contact our distributors in case of any missi

2-2 Part Description  Front Panel Buzzer On/Off Switch Upper deck HDDAccess LED Lower deck HDDAccess LED System Access LEDBuzzer On/Off Access LED

SOHO RAID 8LCD Panel ControllerOperation mode switch Select buttonUpper Deck Removable Carrier Lower Deck Removable Carrier EIDE ControllerDC Power S