Soho 6 Manuel d'utilisateur télécharger pdf (Page 5)

SOHO 6 Wireless Installation Procedures: Macintosh with Internet Explorer 5.x & 6.0 5

Troubleshooting the Connection

stops, the SOHO 6 Wireless reboots.This provides for a more consistent Internet connection but will be seen as

continuous traffic by the ISP and regulated as such.

4Click Submit.

Your installation is now complete, and you should be able to use your Internet connection. Verify this by

accessing the Internet.

Troubleshooting the Connection

You can monitor the connection traffic through the SOHO 6 Wireless using the Event Log.

1 With your Web browser, go to the System Status page using the Trusted IP address of the SOHO 6

Wireless.

For example, go to: http://192.168.111.1.

2 From the navigation bar on the left side, select Logging.

Configure the Wireless Network

The SOHO 6 Wireless protects computers that are connected to it by Ethernet cable or wireless

connection. Because WatchGuard is concerned about the security of your network, the wireless network

is disabled on the SOHO 6 Wireless by default. This allows you to enable the wireless network after you

set up the desired security.

Configure Security

1 From the navigation bar on the left side, select Network => Wireless Configuration.

The Wireless Network Configuration page appears.

2From the Encryption drop-down list, select the level of encryption you want applied to your

wireless connections.

Disabled

The default is Disabled, and you should use this option for the initial connection. Your wireless

connection is not using WEP when Disabled is selected.

40/64 bit WEP or 128 bit WEP

Once you complete the initial connection between your computer and the SOHO 6 Wireless, you

can change this option to use WEP. Select either 40/64 bit or 128 bit based on what the wireless

networking card in your computer supports.

3 If you are using WEP encryption, type a hexadecimal number in the Key text boxes.

You can type up to four keys that the wireless network will use to connect. If you have 40/64 bit WEP, the key must be

10 characters. If you have 128 bit WEP, the key must be 26 characters.

4 If you typed more than one key, select which key you want to use from the Default Key drop-down

list.

5 Select the Authentication mode you want to use for your wireless network connection.

Open System

This option does not support shared keys. If you disable encryption, this is the only option.

Shared Key

This option supports shared keys. If you enabled WEP, this option is enabled.

1 2 3 4 5 6 7 8

Pas de commentaire

Soho 6 Manuel d'utilisateur Page 5